What's Included
- Wash pump and circulation motor repair
- Control board and user interface replacement
- Heating element and NTC temperature sensor replacement
- Water inlet valve and flow meter repair
- Drain pump and drain hose service
- Door latch, seal, and hinge repair
Electrolux dishwashers are engineered for quiet, efficient operation with advanced wash systems and sensor-driven cycles. The EDSH4944A, IQ-Touch, and ComfortLift series deliver superior cleaning performance through precise water temperature control and optimized spray arm design. When error codes i20 through iC3 appear, the dishwasher stops mid-cycle, or water remains in the bottom at the end of a cycle, professional repair restores performance without replacing the appliance.
Common Electrolux Dishwasher Problems We Fix
- Not draining or water pooling in base (i20 drain fault) — drain pump blockage, impeller failure, or drain hose restriction
- Not filling with water or filling slowly (i30 water fill timeout) — inlet valve or water supply issue
- Not heating water properly (i60 water heating timeout) — heating element or NTC sensor failure
- Wash pump not running or weak wash performance (i50 wash motor fault) — circulation motor or capacitor failure
- Water overflow or continuous filling (iF0 overflow detected) — inlet valve stuck open or flow sensor fault
- Control board communication errors (iC0–iC3 codes) — main board or UI board communication failure
- Dishes not clean after cycle completes — spray arm blockage, low water temperature, or detergent dispenser fault
Error Codes We Diagnose
We diagnose all Electrolux dishwasher fault codes: i20 (drain fault), i30 (fill timeout), i40 (water level sensor), i50 (wash motor), i60 (heating), iF0 (overflow), iC0 (main board communication), iC1 (UI communication), iC2 (auxiliary board), iC3 (wash motor board), and ER (general electronic reset). Each code is confirmed at the component level before any part is ordered.
Models We Service
- Electrolux EDSH4944A series built-in dishwashers
- Electrolux IQ-Touch series dishwashers
- Electrolux ComfortLift series dishwashers
- Electrolux EIDW series integrated dishwashers
- Electrolux panel-ready and custom-panel configurations
Our Repair Process
- Inspect: Run a test cycle, check base pan for water, inspect door seal and spray arms
- Test: Retrieve stored fault codes, test pump amperage, measure heating element resistance
- Diagnose: Confirm root cause at the component level
- Estimate: Written cost confirmation before any repair begins
- Repair: Replace or repair faulty component, run full test cycle to confirm resolution
Transparent Pricing
Electrolux dishwasher repairs start from $135 for drain pump and sensor replacements. Wash motor and control board repairs start from $215. All pricing is confirmed in writing before work begins.