Electrolux Ice Maker PF Error: Power failure alert
Electrolux ice maker pf error — understanding this error code helps you decide on the right course of action for your Electrolux appliance. What Does Error Code PF Mean on an Electrolux Ice Maker? Error code PF on Electrolux ice makers is a power failure notification. The control board detected that AC power was lost […]
Yes
DIY Fixable
From $80
Typical Repair Cost
15-30 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Yes. PF is purely informational and does not indicate any malfunction with the ice maker itself. Simply acknowledge the alert and the unit resumes normal operation. Discard any melted/refrozen ice for quality.
Can I reset the code?
Yes. Press any button to clear PF. The unit immediately returns to normal operation. No power cycling needed.
When to stop immediately?
Stop if you notice: PF appears multiple times per week without any known power outages in your area, The outlet or power cord feels warm to the touch.
Symptoms You May Notice
PF flashes on the display after power is restored
The control panel shows PF upon power-up, informing you that the unit detected a power interruption and wants manual acknowledgment before resuming normal display.
Ice in the bin has partially melted and refrozen
After a prolonged outage, ice cubes in the storage bin may have melted into a solid block or clump, indicating the compartment warmed during the power loss.
Unit is not making ice after power returns
The ice maker waits in a standby state showing PF until a button is pressed, so it appears as though the unit is not operating even though power has been restored.
PF appears repeatedly without known outages
The code keeps showing up, suggesting intermittent power drops from a loose connection, tripping GFCI, or an overloaded circuit rather than actual utility outages.
Possible Causes
Utility power outage
The electrical supply to your home was interrupted by a storm, grid maintenance, or area-wide outage, cutting power to the ice maker temporarily.
DIY PossibleTripped circuit breaker or GFCI outlet
The breaker for the ice maker circuit has tripped due to an overload or ground fault, or a GFCI outlet has tripped, cutting power to the unit.
DIY PossibleLoose power cord or outlet connection
The plug is not fully seated in the outlet, or the outlet receptacle has loose internal contacts that intermittently break the electrical connection.
DIY PossibleSafe Checks You Can Do
-
1
Acknowledge the PF alert
Press any button on the ice maker control panel to dismiss the PF display. The unit should return to its normal temperature readout and resume ice production automatically.
On some models, pressing and holding the power button for 3 seconds clears PF.
-
2
Check the ice bin
Open the door and inspect the ice in the storage bin. If ice has melted into a solid block, remove the bin, empty the clumped ice, and reinstall it so fresh ice can accumulate properly.
Running warm water over the outside of the bin makes it easier to release a frozen block of ice.
-
3
Inspect the power connection if PF recurs
Check that the power cord is fully plugged into the outlet. Test the outlet with another device to confirm consistent power. If the unit is on a GFCI outlet, check and reset the GFCI. Consider moving the ice maker to a dedicated (non-GFCI) circuit if trips are frequent.
Ice makers draw surge current on compressor startup which can trip sensitive GFCI outlets.
When to Call a Professional
Contact a qualified technician if:
- An electrician finds a loose neutral or hot wire at the outlet or breaker panel
- The circuit is overloaded — amperage draw exceeds the breaker rating when multiple appliances run simultaneously
- The GFCI outlet trips specifically when the ice maker compressor starts, suggesting a ground fault in the unit
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Ice Maker Repair Service Schedule Appointment