Electrolux Dryer E64 Error: Heater open circuit
Electrolux dryer e64 error — understanding this error code helps you decide on the right course of action for your Electrolux appliance. What E64 Means on Your Electrolux Dryer Error code E64 on Electrolux dryers means the control board detected zero current draw when it energized the heater relay, confirming a complete open circuit in […]
No
DIY Fixable
From $250
Typical Repair Cost
60-120 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
No. While the dryer will not produce heat and therefore poses no immediate fire risk, running it without heat wastes energy and may stress other components. Diagnose and repair before using.
Can I reset the code?
No. An open circuit is a physical break in the electrical path. No amount of resetting will restore the circuit. The blown fuse, broken element, or disconnected wire must be physically repaired or replaced.
When to stop immediately?
Stop if you notice: Stop if you find a blown thermal fuse and also address the root cause of overheating before replacing it., Do not attempt to bypass or jumper the thermal fuse, as it is a critical fire safety device..
Symptoms You May Notice
No heat at all
The dryer tumbles normally but produces absolutely no heat throughout the entire cycle, leaving clothes completely wet.
E64 displayed on control panel
The error code E64 appears shortly after starting a heated drying cycle, indicating the board confirmed zero heater current.
Sensor dry cycles end immediately
Auto-dry or sensor-dry cycles may end within a few minutes because the sensors detect no moisture reduction.
Dryer runs normally on air-fluff
Non-heated cycles like Air Fluff or Rack Dry (no heat) work perfectly, confirming the motor, drum, and airflow are fine.
Possible Causes
Blown thermal fuse
The thermal fuse, a one-time safety device in the heater circuit, has blown due to overheating, permanently breaking the heater circuit until replaced.
DIY PossibleBurned-through heating element
The nichrome heating coil has burned completely through at one point, creating a permanent open circuit that prevents any current flow.
Requires ProfessionalDisconnected heater wiring
A wire connector has come loose or a wire has broken in the circuit between the control board relay and the heating element assembly.
DIY PossibleSafe Checks You Can Do
-
1
Check the thermal fuse
Unplug the dryer and locate the thermal fuse on the blower housing or exhaust duct. Visually inspect it for discoloration, or test continuity with a multimeter if available.
The thermal fuse is a small device about 1 inch long with two wire terminals. If it has no continuity, it has blown and must be replaced.
Tools required -
2
Inspect the heating element
Remove the access panel and look at the entire length of the heating element coil for a visible gap or break in the wire.
The break is often near one of the terminal ends or at a point where the coil has been stressed by vibration.
-
3
Verify wiring connections
Trace the wiring from the heating element back toward the control board. Check each connector for a secure fit and look for broken wires.
Pay special attention to any wiring that passes near moving parts or sharp metal edges that could have chafed through insulation.
When to Call a Professional
Contact a qualified technician if:
- The thermal fuse has blown, indicating a prior overheating event that also needs root-cause investigation.
- The heating element reads infinite resistance (open circuit) when tested with a multimeter.
- All heater circuit components test good individually, suggesting a control board relay or trace failure.
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Dryer Repair Service Schedule Appointment