What's Included
- Bake and broil element replacement
- Electronic oven control (EOC) board replacement
- Temperature sensor (NTC) calibration and replacement
- Convection fan motor repair
- Door hinge, latch, and seal repair
- Self-clean cycle fault diagnosis and repair
Electrolux single and double electric wall ovens — including the ECWD3012A series — deliver precise convection performance through advanced electronic oven controls and multiple cooking modes: conventional, true convection, broil, and combination programs. When your Electrolux oven stops heating, shows F-code errors (F10 through F91), or the door will not seal properly, professional repair restores full cooking performance.
Common Electrolux Oven Problems We Fix
- Oven temperature sensor runaway (F10) — sensor detecting dangerously high temperature, sensor or control board fault
- Oven temperature sensor shorted (F11) — NTC sensor short circuit or wiring damage
- Internal board communication error (F13) — EOC board internal communication failure
- Keypad or touch panel disconnected (F14) — ribbon cable or keypad connection fault
- Door lock fault during self-clean (F30) — door lock motor, switch, or actuator failure
- Temperature exceeded safe range during self-clean (F31) — high-limit thermostat or relay fault
- Keypad shorted (F90) — touch panel membrane or connector fault
- Keypad open circuit (F91) — keypad wiring or control board fault
Models We Service
- Electrolux ECWD3012A single and double wall ovens
- Electrolux EW series wall ovens
- Electrolux EI series built-in ovens
- Electrolux combination microwave-oven units
- Electrolux legacy wall oven models
Our Repair Process
- Inspect: Test all oven modes, check door seal and hinge condition
- Test: Measure element resistance, test NTC sensor values, check EOC board outputs
- Diagnose: Confirm root cause component
- Estimate: Written cost confirmation before work begins
- Repair: Replace faulty part, calibrate temperature, test all cooking modes
Transparent Pricing
Electrolux oven repairs start from $145 for element and sensor replacements. EOC board and door lock repairs start from $245. All pricing confirmed in writing before work begins.