Oven Diagnostics
Electrolux Oven
Electrolux Oven
Error Codes
Meanings, severity levels, safe checks you can perform, and when to call a technician.
Enter the code shown on your oven display
Is it safe to keep using it?
Depends on code severity. Low/Medium codes often allow continued use, High severity requires immediate stop.
Can error codes be reset?
Some codes clear after power cycle. Persistent codes indicate underlying issues needing repair.
When should I stop using it?
Stop immediately for water leak codes, burning smell, or any High severity error.
Error Code Directory
Click any code for detailed troubleshooting steps
Low
Medium
High
Code
Meaning
Severity
Common Symptom
F10
Open temperature sensor circuit — no temperature feedback to control board.
High
The wall oven shows F10 on the digital readout with an audible alarm. All oven heating functions are disabled until the fault clears.
View
F11
Shorted oven temperature sensor — NTC resistance abnormally low.
High
The wall oven displays F11 on the control panel with an audible alarm and refuses to start any heating function until the fault is addressed.
View
F13
EEPROM fault — control board cannot read stored configuration data.
High
The wall oven shows F13 immediately upon power-up or when you first attempt to use a function, indicating the EEPROM read failed during the control board initialization sequence.
View
F14
Control board software fault — microprocessor execution error detected.
High
The wall oven shows F14 on the digital readout, potentially accompanied by an alarm. The display may freeze or the oven may restart itself before showing the error.
View
F30
Open temperature probe circuit — probe disconnected or wire broken.
High
The wall oven shows F30 on the control panel and sounds an alarm. All heating functions are locked out because the control board has no temperature reference.
View
F31
Shorted temperature probe — probe resistance abnormally low.
High
The wall oven shows F31 on the control panel and beeps. All oven heating functions are locked out until the shorted probe condition is corrected.
View
F90
Door latch motor stuck — motor cannot complete lock or unlock travel.
Medium
The wall oven displays F90 when you initiate a self-clean cycle because the latch motor cannot lock the door within the expected time window.
View
F91
Door latch switch not responding — no lock position feedback.
Medium
The control panel shows F91 when you try to start a self-clean cycle because the control board cannot confirm the door has been locked by the latch mechanism.
View