Electrolux Dishwasher I60 Error: Heating / temp sensor fault
Electrolux dishwasher i60 error — understanding this error code helps you decide on the right course of action for your Electrolux appliance. What Does Error Code i60 Mean on an Electrolux Dishwasher? Error code i60 on Electrolux dishwashers signals a heating system fault. The control board monitors water temperature through an NTC thermistor sensor during […]
Sometimes
DIY Fixable
From $150
Typical Repair Cost
30-60 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Maybe. The dishwasher may complete cycles at a lower temperature, but sanitization and cleaning performance will be severely compromised. Dishes may not be hygienically clean, especially if the water never exceeds 120°F.
Can I reset the code?
Yes. Power-cycling the dishwasher will clear i60 from the display. However, the next cycle that requires heating will trigger the fault again if the element or sensor has failed.
When to stop immediately?
Stop if you notice: Descaling does not improve water temperature and i60 recurs every cycle, The door panel feels completely cold even 20 minutes into a hot wash.
Symptoms You May Notice
Dishes come out cold and poorly cleaned
Without adequate water temperature, detergent cannot dissolve properly and grease is not broken down, leaving dishes with residue and food particles.
Cycle runs much longer than normal
The machine extends the wash phase trying to reach the target temperature, causing a cycle that normally takes 60 minutes to run 90 minutes or more before eventually faulting.
i60 appears mid-cycle during the main wash
The error typically triggers during the main wash or sanitize phase when the control board determines the temperature target will not be met in time.
Steam is absent when opening the door after a cycle
Normally, opening the door after a hot cycle releases visible steam. With a heating fault, the interior feels only lukewarm.
Possible Causes
Failed heating element
The resistive heating element in the sump has burned out or developed a high-resistance break, preventing it from generating heat when energized by the control board.
Requires ProfessionalFaulty NTC temperature sensor
The thermistor has drifted out of calibration or failed, causing it to report inaccurate temperatures to the control board even though the element may be working.
Requires ProfessionalHeavy limescale on the element
Mineral deposits from hard water have insulated the heating element surface, drastically reducing heat transfer to the water.
DIY PossibleSafe Checks You Can Do
-
1
Run a descaling cycle
Place a dishwasher-safe descaling product or 2 cups of white vinegar in the bottom of the empty dishwasher. Run a hot cycle with no dishes. This may dissolve limescale buildup on the element surface.
In hard water areas, descale monthly to prevent scale-related heating issues.
-
2
Check incoming water temperature
Run the kitchen hot tap for 2 minutes and test the water temperature with a cooking thermometer. It should be at least 120°F (49°C). If it is significantly lower, the dishwasher heater has to work much harder.
Consider raising your water heater thermostat if it is set below 120°F.
Tools required -
3
Reset and monitor
After descaling, run a normal cycle and monitor the door temperature by touch during the main wash. The door should feel warm after 15-20 minutes if the element is heating.
If the door remains cold throughout, the element is likely failed and needs professional testing.
When to Call a Professional
Contact a qualified technician if:
- A multimeter reading across the heating element terminals shows infinite resistance (open circuit)
- The NTC sensor resistance does not change when the dishwasher is cold vs warm
- Visible damage, discoloration, or pitting on the heating element surface
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Dishwasher Repair Service Schedule Appointment