Range Diagnostics
Electrolux Range
Electrolux Range
Error Codes
Meanings, severity levels, safe checks you can perform, and when to call a technician.
Enter the code shown on your range display
Is it safe to keep using it?
Depends on code severity. Low/Medium codes often allow continued use, High severity requires immediate stop.
Can error codes be reset?
Some codes clear after power cycle. Persistent codes indicate underlying issues needing repair.
When should I stop using it?
Stop immediately for water leak codes, burning smell, or any High severity error.
Error Code Directory
Click any code for detailed troubleshooting steps
Low
Medium
High
Code
Meaning
Severity
Common Symptom
F10
Runaway oven temperature — oven exceeds set temp by 50°F or more.
High
The range displays F10 on the digital readout and may emit a continuous beeping alarm to alert you of the runaway temperature condition.
View
F11
Shorted oven temperature sensor — NTC resistance too low.
High
The range displays F11 on the control panel and refuses to start any oven heating cycle, including bake, broil, and self-clean.
View
F30
Open oven temperature sensor — NTC circuit broken or disconnected.
High
The digital display shows F30 and the range beeps to alert you. The oven will not accept any heating commands until the fault is cleared.
View
F31
Confirmed shorted oven temperature sensor — secondary verification.
High
The control panel shows F31 and it does not clear after pressing Cancel, indicating the short circuit has been confirmed by the control logic.
View
F90
Door lock motor circuit fault — self-clean lock motor not responding.
Medium
The range displays F90 when you attempt to start a self-clean cycle, and the cycle does not begin because the door fails to lock.
View
F91
Door lock switch circuit fault — lock position feedback missing.
Medium
The control panel displays F91 when you attempt to initiate a self-clean cycle because the control board cannot confirm the door has locked.
View
F92
Keypad / membrane switch fault — stuck or unresponsive key detected.
Medium
The range shows F92 on the digital display and may beep. Some or all control buttons may become unresponsive as the board enters a protective lockout.
View
F93
Internal latch motor failure — motor runs but cannot complete travel.
Medium
The range displays F93 when you start a self-clean cycle and the latch motor cannot complete its travel to lock the door within the expected time window.
View